#211 BOTTOM PLATES

Fully Adjustable 7” plate can be used on sand to eliminate augering.  If can also handle rocks and light muck.  For easier installation use bottom plates whenever possible and only auger where needed to hold a boat.

#200 AUGERS

Augers are necessary where you are going to tie a larger boat directly to a dock.  Usually you only need to put them on the poles near the boat.  They are also necessary on docks that don’t have a stringer bracket system.

#300C SUPER CLAMPS

This clamp secures the cross arm to a 2” dia. upright.  Unlike other brands, our super clamp doesn’t require complete disassembly to just to make a simple adjustment.  One turn on the outside bolt allows the upright to be adjusted in seconds.  Forget stampings or cheap foreign castings that break.  Our clamps are American made and can’t be over-tightened.

#105 STRINGER REST

Only from Alumi-Span, this inexpensive component can be used in place of a stringer bracket in many applications to greatly simplify assembly.  Stringer Rests simply push onto any horizontal 2” dia. pole to provide a flat area for resting dock sections where they meet on a party platform truss.  It also creates a flat spot to rest deck center supports on regular sections.

#212 LARGE BOTTOM PLATES

This clamp on device can clamp anywhere up and down the upright (no unreliable thumbscrews).  It can be used in serious muck or as a base for our lightweight trusses allowing them to stand up in the water for easy installation of the platform

#220 MUD AUGERS

These special augers work nicely in mucky situation since the larger 11” diameter supports much more weight in muck conditions then a smaller auger.  #220 augers can be used in combination with #200 augers for easier installation.

#330 H.D. CLAMPS

Typically shown with an angle bracket as shown, this assembly allows you to clamp anywhere on a 2” dia. Tube and attach boards, signs, etc. by simply bolting them to the heavy duty 2”X2” bracket.

#500 & #501 DIAGONAL BRACE BOLTABLE END ASSEMBLYS

While not as popular as our “snap on” diagonal braces, these castings allow you to bolt tubes together at almost any angle for special applications and also serve as replacements pieces for our older style braces

#310A & #315 TRUSSES CASTINGS

These castings are used to connect 2” dia. Tubes together in the construction of our trusses.  They also can be used to replace older #310, #311, and #312 castings

PERMA AUGER

Designed to allow an augered dock installation without any of the work!  Like our famous “Big Foot”, Perma Auger is heavy duty and designed to be left in the water under the ice line year around.  Regular uprights simply drop right into them.  Perma Augers cut installation times by 65% and the dock is always perfectly positioned.  Comes with a plastic guide so deeper water installation is easy.

BIG FOOT SYSTEM

Our Famous Big Foot system, designed for mucky bottoms, stays in the water year around below the ice line.  It provides a permanent base that our standard leg assemblies or individual uprights can drop into.  This greatly reduces installation times and also gives you something to stand on while in the water.  No more augering or yearly adjustments.  The dock is perfectly positioned.  Big Foot includes plastic pole guides and a variety of board sizes are available.  Properly set up, you can installation a regular alumi-span section in about 3 minutes.